How to use:

Use the device with massage-like movement starting at the center of the face and going outward towards the temples. Spread gel all over the face, neck, and chest or pump gel directly on the top of the device and apply to localized areas. Make slow, long movements from the chin up towards the temple. Make up and down zig-zag on the forehead up to the hairline. Move from under the eyes to the temple and the inner brow towards the temple. Use circular movement in the area between the brows. Make circular movements on the highest point of the cheekbones. To create the lowlight shadow look, use the EMS settings in the hollow part of the cheeks and pull towards the temples.

Move up the neck from the base of the neck towards the ears. Move from the center of the chest and towards the tip of the shoulders and feather off to the end.

SETTINGS:

Clean Function uses Ultrasonic vibration, and Green LED light. Use this setting on a clean, wet face. The ultrasonic waves will use the water to clean your face. The RF will warm your face and open up your pores. Green light helps reduce redness, calms your skin, and helps with acne and rosacea-prone skin. Remember, green neutralizes red! This setting preps the skin for the settings that follow. Use on the skin in movements similar to massage movements and spreading products on the skin. Use long strokes upward and from the center of the face towards the temples.

Penetration delivers light Electrical Muscle Stimulation current into the skin with Red LED light. This setting pushes the product into your skin, allowing it to soak deeper with the muscles activated and delivering nutrients deep into the base layer of your skin. This function is very effective when paired with our Aloe Vera Collagen Gel. Spread the gel all over your face and neck, or pump the gel directly onto the device head. Our gel is designed as a conductor to help the red light penetrate deep into your skin. Using a conductor to reach the intended light and electrical current target. Our gel is the only of its kind designed to be a balanced meal for the skin, and it should soak into your skin. If your face absorbs the water and nutrients, add more. The Gel is packed with water, collagen, nutrients, hyaluronic acid, amino acids, and epidermal growth factor derived from rice to grow your skin from the hypodermis.

Lifting function delivers a stronger EMS current with ultrasonic vibration and a Red LED light. The red light helps with hyperpigmentation and helps build collagen and elastin, the part of your skin that gives you the youthful cushion. Ultrasonic vibration causes fat cells to burst, releasing glycerol, which moisturizes and is used up by the skin, and fatty acids, which drain through lymphatic drainage. EMS tones muscles and increases its strength to help with facial function and lift the face.

Beauty uses Radio Frequency and Yellow LED light. RF warms the skin, prompting it to produce elastin and collagen. This noninvasive treatment promotes cell turnover, making the skin firmer and thicker. It’s great for the face, neck, belly, and upper arms. Red light helps with inflammation and redness on the skin. This is when you can add a targeted serum to your session. Use rose for mature, dry skin and boost collagen and elastin. Use Copper for sensitive, acne, and rosacea skin to calm the redness and promote skin repair.

Eye uses RF and Ultrasonic around the sensitive eye area to help reduce puffiness while promoting collagen and elastin formation to minimize lines and smooth the skin.

Cool function delivers a cold current on the skin and a Blue LED light. Blue LED light fights acne, promotes wound healing and is antibacterial. It also helps with inflammatory issues such as atopic dermatitis, eczema, and psoriasis. The coolness on the skin calms and soothes while closing pores, signaling the end of the sculpting session and transitioning clients out of service while maintaining relaxation.